• Front Truck

Replacement Front Trucks can be purchased from our Parts Store here


  • Skate Tool
  • 3mm Allen T-Tool (Optional)

Riptide Master Tool Kits can be purchased in our Parts Store here


Take your board and put it onto a box that is tall enough to lift the wheels off the table.

Remove the Allen Wrench from the Skate Tool. Use the mini Allen Wrench and the Skate Tool to remove one of the front truck screws and nuts.

You may also use a 3mm Allen T-Handle, if available.

Take off the nut and pull out the screw. Put these to the side.

Repeat these steps to remove the other three truck screws and nuts. Note that when you remove the final screw the truck will fall so make sure to be ready for it. Put the front truck to the side.

Grab your board, holding the battery box to the deck. Flip it over and hang the nose off of the deck.

If your risers become dislodged, make sure to replace them.

Place the new truck.

Hand tighten the truck screws and nuts. Then use the 3mm Allen and Skate Tool to secure them.

To move your wheels from your old front truck to the new front truck, see these directions.

Front Truck